ARDE Barinco, Inc., is proud to announce that we will be exhibiting at the CHEM Show and you are personally invited to stop by the ARDE Barinco booth no. 103.

We will have on display three different laboratory mixers including the Model CJ-2A, Model CJ-4E with Power Lift, Model CJ-4E with Powder Induction Device and also a Model DH-050 on a center table. All of these will be installed and running. We will be exhibiting the Model CJ-20-2 Reversible Homogenizer with Powder Induction Device on the transparent 150 gallon display tank.

We will have the Model 1010 Cavitron new tungsten carbide parts available for your inspection. These are special 12,000 RPM parts designed for fine abrasive powders.

Of special interest is our ongoing research with Lenterra, Inc., who has developed a new sensor capable of directly measuring shear stress at the wall of the starter in the gap between the rotor and stator of our high shear mixer. View the fine partical study here  Lenterra will also have an exhibit with the Model CJ-4E Reversible Homogenizer at booth 644.

It wouldn't be a Chem Show if we didn't fill up a clear tank and do some mixing. Our CJ-20-2 mixer with Powder Induction Device will be hooked up to 3 phase power and running. We have a full D-6000 Dispershear available to take apart and re-assemble. The 10 x 6 MEGAGRINDER will be there for inspection. We'll leave the 100 HP motor for the 10 x 6 MEGAGRINDER home though.

Finally, if we get time, we'll be mixing up some good oil in water emulsions. We call those lotions "Oil of ARDE". Hope to see you in New York City.